Stages of creation of an adhesive

An adhesive is created in several stages

First it's necessary to prepare the computer file which will allows the machine to realize the cutting.

Then, we place the material on the machine and we begin the cutting. The machine blade cuts the material according to the file previously prepared on the computer.


Once the cutting is finished, we need to remove the superfluous material. This work take more or less time depending on the shape and complexity of the adhesive.






It only remains to recover the result with transfer paper, to make the laying easy.

Laying of the adhesive

To lay the adhesive,you need to begin by cleaning up the place where you're going to stick it. Unstick the transfer paper,lay the adhesive. It only remains to remove the transfer paper and it's over !

If it's a big adhesive and you need to place it accurately, you can wet the support with soap water. It will allows you to place your adhesive making it slide. Wait until the sloap water has dried to remove the transfer paper.